Functions and Features
The rear panel shown in the figure is only an example. The actual appear-
ance of the rear panel is subject to the specific instrument.
The procedures to set the channel number are as follows.
1. Set the channel number for each instrument.
a. Press [Shift]+[Display] (System) to enter into the system menu
interface.
b. Use left and right keys or rotate the knob to select Chan Number and
press [Enter] key to make the parameter in modification.
c. Rotate the knob to adjust the value and set the channel number. Press
[Enter].
d. Repeat steps a through c to set the channel number for other power
supplies.
2. Connect the instruments according to the above diagram. Please disconnect
the power before wiring.
a. Connect system bus interfaces.
b. Connect the DUTs. Refer to 2.6 Connecting the Device Under Test (DUT)
for more information about connection methods.
c. Connect the power supply to PC.
Copyright © Itech Electronic Co., Ltd.
56
To Next Page
Loading...
Need help?
General
