To Next Page

To Previous Page

Basic Operations

6. Set “Total Slave Unit” as 5, as shown below:

7. After saving the settings, the user must power off the six electronic loads

and power on again.

Configure the Phase A/A/B/B/C/C of the six electronic loads on master.

1. Press [Menu] to enter the system menu setting interface.

2. Select [PARALLEL SETUP] to enter the parallel setting interface.

3. Press the Up and Down key to select the “Single/Three Phase” > “A+B+C”.

4. Press [EDIT PHASE], configure the Phase A/A/B/B/C/C of the six

electronic loads.

5. Press [Enter] to save the setting.

6. After saving the settings, the user must power off the master and power on

again.

3.20 Three-phase setup

You can set different power or current in three-phase mode. Press [Enter] to

save the parameter of three-phase, then press [Set] to enter into the configure

interface, as shown as below.

ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com

ITech IT8600 Series User Manual

Other manuals for ITech IT8600 Series