Measurement Functions
Copyright © ITECH Electronic Co., Ltd. 59
Chapter5 Measurement Functions
This chapter describes the characteristics and operations of the basic metering
function of IT8600 electronic load.
IT8600 electronic load has rich functions of basic metering of electric energy
and can accurately measure the parameters such as Vrms, Vpk, Vdc, Irms, Ipk,
Idc, W, VA, VAR, CF, PF and Freq.
5.1 Interface Introduction
Peak Holding Mode
On: to enable the peak holding mode. Measurement data
are updated if peak data are sampled.
Off: to disable the peak holding mode.
Configuration of basic metering.
5.2 Parameter Measurement
The measured value displayed in large letters on the upper part of the interface
can be modified according to the user requirements. Press [CONFIG] to enter
the metering parameter configuration interface. Press the soft key
corresponding to the metering parameter.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
