Load Functions
Copyright © ITECH Electronic Co., Ltd. 55
⚫ Pset=50.0W: constant power of CP Mode.
⚫ CF=1.414: crest factor, 1.414 to 5.000.
⚫ PF=1.000: power factor. It cannot be edited.
5. Press [Enter] to confirm.
6. Press [On] to enable load input. Loading will be started and the current will
sink.
PF Mode
⚫ Mode setting
The initial default mode of IT8600 electronic load is the “BOTH” mode. PF Mode
can be set in the same method as in CC Mode. Refer to 4.2.2 “Constant Current
Mode”.
⚫ CP parameter setting
The user can press the Up and Down key in the main interface of CP Mode to
select the parameter to be set, including PF and Pset. The user can also rotate
the knob to set the current value or press numeric keys to input the set value.
The PF range is -1.000 to 1.000.
1. Press [Set] to enter the parameter setting interface of CC Mode.
2. Press the soft key corresponding to CP to enter the CP mode setting
interface.
3. Press the Up and Down key to select the parameter to be set.
4. Directly set the present value through the knob or press numeric keys to
input the value. In case of wrong input by numeric keys, press to
delete the present input.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
