en 12
2 SAFETY
J. Keep your hands and feet away from parts that move. Do not adjust the mower with the engine in operation,
unless the adjustment needs the engine in operation.
K. Take care working on cutting units and moving parts with stored energy.
L. To prevent injury from the hot, high pressure oil, never use your hands to check for oil leaks. Use paper or
cardboard to find leaks.
M. The hydraulic fluid pressure can have enough force to enter your skin. If hydraulic fluid has entered your skin,
seek medical attention immediately.
N. When you service the hydraulic system, make sure the hydraulic fittings, tubes and hoses are tightened to the
correct torque (where applicable). Make sure the hydraulic system is in good condition before you start the
engine.
O. Keep the mower and the engine clean.
P. Allow the engine to become cool before storage and always remove the ignition key.
Q. Keep all nuts, bolts and screws tight to make sure the equipment is in safe condition.
R. DO NOT operate the machine if you have worn or damaged parts for safety. Replace damaged or worn decals.
Only use parts, accessories and attachments approved by Ransomes Jacobsen.
S. To decrease the fire hazard, remove materials that burn from the engine, muffler, battery tray and fuel
tank area.
T. Disconnect the battery and controller connectors before you weld on this mower.
2.8 WHEN YOU PUT THE MOWER ON TO TRAILER____________________________
A. Be careful when you load or unload the mower on a trailer. The trailer must be wider than the mower and can
carry the weight of the mower.
B. Use a full-width ramp to load or unload the mower on a trailer.
C. Use appropriate securing methods to fasten the mower to the trailer. Both front and rear straps must be sent
down and towards the sides of trailer.
D. Make sure that all latches are correctly fastened.
To Next Page
Loading...
Need help?
General
