Reversing Switches
This is an electronic means of reversing the throw of a given
(servo) channel. All ten (10) channels of the 10X offer servo
reversing. This will ease setup during servo installation.
Accessing and Utilizing the Servo Reversing
Function
Prior to accessing the servo reversing feature, determine which
servos’ travel needs to be reversed. To do so, move the controls of
your 10X and observe the travel direction of each servo. If the
respective servo is not moving properly (i.e., not in accordance
with the control input), then reverse its direction.
Upon determining which channels need to be reversed, access the
Servo Reversing function by entering Code 11 in the code num-
ber access selection or by using the direct mode method.
The screen will appear as follows:
To reverse the travel direction of any servo (channel), simply
touch the number that correlates to that channel. Note that the
shaded portion of the upper box moves to the opposite position.
This indicates the travel has been reversed.
Upon completing the servo’s travel direction, press ENTER to
exit this feature and memorize the servo travel direction.
Note: Normal is the factory default setting for all channels.
Data Reset (Code 28) will reset all servos to the normal direction.
10X MANUAL Airplane
13
To Next Page
Loading...
Need help?
General
