Modulation Selection
This Modulation Selection function enables your 10X to transmit
to a variety of JR receivers that are already or may soon be in
existence. You can select from either of two types of PCM,
ZPCM or SPCM, depending on the central processing unit within
your receiver. Or you can select PPM (pulse position modula-
tion). Refer to the receiver compatibility chart for the correct
modulation.
Accessing and Utilizing the Modulation Selection
Function
To access the Modulation Selection funciton, enter Code 85 at the
code number access selection or use the direct mode method.
The screen will display:
The type of modulation currently being used appears above the
SEL key on the display screen. To change modulation types,
touch the SEL key.
Note: Any time Code 28, Data Reset, is used, the 10X reverts
back to the factory default of SPCM.
Note: The modulation selection process takes place immediate-
ly. There is no need for the power switch to be turned off.
To exit the Modulation Selection function, touch the ENTER key
after selecting the proper modulation.
If you want to verify the modulation of your transmitter at any
time, simply return to the initial info screen. The screen below
appears:
Receiver Compatibility Chart
Note: The 10X cannot be used with the NER-627x, NER-629x
or the NER-J229p receivers. The central processing units (or
CPUs) are not compatible.
62
10X MANUAL Airplane
8.25
Code 85
To Next Page
Loading...
Need help?
General
