Sub-Trim Adjustment
The Sub-Trim Adjustment is a feature that allows you to elec-
tronically fine tune the centering of your servos and is individual-
ly adjustable for all ten (10) channels with a range of +/-250% in
2% increments (+/-30° servo travel).
Accessing and Utilizing the Sub-Trim Adjustments
To access the Sub-Trim Adjustments, enter Code 15 in the code
number access selection or use the direct mode method.
The screen will appear as follows:
This feature enables you to electronically correct for slight
mechanical misalignments that previously had to be corrected
manually.
Caution: Do not use excessive sub-trim adjustments since it is
possible to overdrive your servo’s maximum travel if it is off-
center. Remember that this is a trim convenience feature. It is not
intended to take the place of the proper mechanical trim adjust-
ments that are necessary on any R/C model. Offset servos can
produce a differential throw effect.
Press the + or - key to increase the amount of sub-trim. To reset
the sub-trims to the factory default of 0, press the + and - keys
simultaneously or press the CL key.
After adjusting the sub-trims for the first five channels, touch the
PAGE key to access the last five channels.
Upon completion of the sub-trim adjustments, press the ENTER
key to memorize the settings and to exit the program.
Note: On previous generation of JR’s 10-channel computer
radios, the sub-trim adjustment values are adjustable from 0 to
125% in 1% increments. Your 10X in adjustable in 2% incre-
ments up to 250%. If you’re transferring over sub-trim values
from a previous generation JR 10-channel radio to the 10X, the
sub-trim values of the older 10-channel radio must be doubled in
order to properly match when programmed into the 10X.
18
10X MANUAL Airplane
To Next Page
Loading...
Need help?
General
