– 57 –
As a result of computerization of the feed mechanism, various adjustments can be carried out. Refer to "4-2.
Sewing patterns" p. 30 for details.
The length of needle thread remaining on
the material after thread trimming is re-
duced by operating the thread trimmer with
feed dog ❶ lowered.
In addition, since feed dog ❶ does not
protrude from throat plate ❷, the material
can be placed/removed on/from the sewing
machine with ease.
* The setting of "Lowering/Not lowering the
feed dog during thread trimming" can be
changed over with "Memory switch U057".
5. MAIN NEW FUNCTIONS
5-1. Shorter-thread remaining thread trimming
The shorter-thread remaining
function is in the OFF state.
❶
❷
The shorter-thread remaining
function is in the ON state.
(State at the time of shipment
from the factory)
❶
❷
Due to computerization of the feed mechanism, the machine generates noise that is specic to
the stepping motor when it runs at a low speed. This noise is not a sign of fault.
[How to set the feed dog]
1) Press ❾.
❾
2) Select "01 Memory switch" by pressing
❶. Press ❺.
❶❺
To Next Page
Loading...
Need help?
General
