25
6.
OPERATION OF THE SEWING MACHINE (ADVANCED)
P-No. Selection key P-No. Selection key P-No. Selection key P-No. Selection key
P1 P1 P8 P1+P4 P15 P4+P5 P22 P2+P3+P4
P2 P2 P9 P1+P5 P16 P1+P2+P3 P23 P2+P3+P5
P3 P3 P10 P2+P3 P17 P1+P2+P4 P24 P2+P4+P5
P4 P4 P11 P2+P4 P18 P1+P2+P5 P25 P3+P4+P5
P5 P5 P12 P2+P5 P19 P1+P3+P4
P6 P1+P2 P13 P3+P4 P20 P1+P3+P5
P7 P1+P3 P14 P3+P5 P21 P1+P4+P5
(1) Register to the pattern key
Setting example : Register following setting to the P2., Pattern No. 3, X scale rate : 50%, Y Scale rate :
80%, Max. speed limitation : 2,000 sti/min, Thread tension : "50", Pattern position : 0.5
mm to the right and 1 mm to the front
1) Turn ON the power switch and press MODE key
to enter mode setting (memory switch
setting). (SET READY LED
should be put out.)
Press ITEM SELECT key
to select "04
Direct pattern regist".
Press EDIT key
to display the pattern
registration mode.
2) Press ITEM SELECT key
to set the
standard pattern to No. 3. Press DATA CHANGE
key
to set P-No. to 2.
When you press the READY key
, P2
is registered and the mode screen is displayed.
Press MODE key
or RETURN key
.
* When the select key is held pressed for one sec-
ond in the state where the standard pattern or
user pattern is selected on the data input screen,
this screen can be displayed.
6-1. Performing sewing using the pattern keys
Patterns (No.1 to 200) which have been already registered can be registered to P1 to P50. It is possible to
change and register the scale, max. speed limitation, thread tension and sewing position. Same as the pat-
terns (No.1 to 200), P1 to P25 are used by the selection by scrolling the pattern Nos. The pattern calling from
P1 to P25 can be made by one-touch as well.
* When selecting P6 to P25, perform the selection by combination (simultaneous pressing) of
and
)
keys as shown in the table below.
To Next Page
Loading...
Need help?
General
