49
7-10. Replenishing the designated places with grease
When the sewing machine has been used for a cer-
tain number of times of sewing, error code No. E220
is displayed on the operation panel at the time of
turning ON the power. This display informs the oper-
ator of the time of replenishing the designated places
with grease. Be sure to replenish the places with the
grease below. Then call the memory switch No. 245
and set it to "0" with the RESET key
.
Even after the display of the error No. E220, when
the RESET key
is pressed, the error is re-
leased, and the sewing machine can be continuously
used. Afterwards, however, the error No. E220 is dis-
played every time the power is turned ON.
In addition, when the sewing machine is used further
for a certain period of time after the display of error
No. E220, the error No. E221 is displayed and the
sewing machine fails to operate since the error can-
not be released even when the RESET key
is pressed.
When the error No. E221 is displayed, be sure to
replenish the designated places below with grease.
Then start up the memory switch and set No. 245 to
"0" with the RESET key
.
1. After replenishing the places with
grease, the error No. E220 or No.
E221 is displayed again unless the
memory switch No. 245 is changed
to "0".
2. Use grease tube (Part No. 40006323)
supplied as accessories to replenish
the designated places below with
grease.If grease other than the des-
ignated one is replenished, damage
of components will be caused.
To Next Page
Loading...
Need help?
General
