– 1 –
1. SETTING OF THE MOUNTED MACHINE HEAD
(Caution) For the function setting procedure of any operation panel other than CP-18, refer to the Instruc-
tion Manual for the operation panel to be used.
1) How to enter into the function setting
mode
Turn ON the power with
switch
held pressed. (The item which has
been changed during the previous
work is displayed.)
* If the screen display does not change,
re-carry out operation described in
step 1).
(Caution)
Be sure to re-turn ON the power switch
when one or more seconds have passed
after turning it OFF. If the power switch is
re-turned ON immediately after turning it
OFF, the sewing machine may fail to op-
erate normally. In such a case, be sure to
turn ON the power switch again properly.
2) Press switch
or switch
to call out function setting No.95
(mounted head).
3) Press
switch
or switch
to select the mounted head. Refer
to Table 1 (p.2) for the relationship
between the head type and the panel
display.
4) After selecting the head type, press
switch
or switch
, and
turn the power OFF.
(Caution)
If the power is turned OFF before car-
rying out this procedure, the changed
content is not updated. When
switch
is pressed, the display on the pan-
el changes to the previous setting No.
When
switch
is pressed, the dis-
play on the panel changes to the subse-
quent setting No. After completion of the
operation, the machine is returned to the
normal sewing state by turning OFF the
power and re-turning it ON.
To Next Page
Loading...
Need help?
General
