– 18 –
11. LU-2200N-7 SERIES THICK THREAD CUTTING
When a thick thread (equivalent to #4 or higher) is used and the thread cannot be cut, make the setting of the
function described below.
Function
Function No. 143
Brake starting angle of
thread trimming UP stop
Brake starting angle at the time of thread trimming UP stop is set.
Setting range : 0 to 10 degrees
Set value at the time of delivery from factory : 0 degree
Set the UP stop position so that the pointer aligns with en-
graved marker line F of the handwheel.
Setthevaluethatissetrstto"7"degreesandconrmtheUP
stop position.
When the UP stop position exceeds engraved marker line F,
decrease the set value of the undermentioned 3) by one and
conrmtheUPstopposition.
When the UP stop position is located on this side from en-
graved marker line F, increase the set value of the undermen-
tioned3)byoneandconrmtheUPstopposition.
Set function No.56 (Reverse needle up after thread cut func-
tion) to "0: null”, cut the thread, and verify if the cutting was
appropriately done.
Pointer
Marker line F
of handwheel
F
E
[How to make the setting]
1) Refer to "1. Setting of the mounted head, 1) How to enter into the function setting mode”, and enter into
the function setting mode.
2) Press
switch
or switch
to call out function setting No.143.
3) Press
switch
or switch
and set the angle.
4) Press
switch
or switch
and return to the function setting mode.
To Next Page
Loading...
Need help?
General
