8 Operation of the Control
8.1 Operation without operator
A special HSP5 cable (material number 00F50C0-0010) is available for operating the
COMBIVERT without operator. The cable is connected between HSP5 interface X4A
and serial RS232 PC interface (COM1 or COM2). Operation occurs via the program
COMBIVIS 5. The KEB-USB converter or the Port-Expander is required for COMBIVIS 6.
RS232-HSP5 converter
Drive converter
X4A
HSP5
TTL
PC
1
5
1
5
6
9
PC
COM-Port
NOTICE
The RS232-HSP5 service cable has an integrated level converter. The
connection of a serial standard cable would destroy the PC interface.
8.2 Operation with digital operator
A digital operator is available as an accessory for local operation of the COMBIVERT. To
prevent malfunctions, the drive converter must be brought into status nOP before con-
necting / disconnecting the operator (open control release terminal). When starting the
drive converter, it is started always with the last stored values or factory setting.
Digital operator (Mat.No. 00F5060-1000)
START
FUNC.
SPEED
ENTER
F/R
STOP
COMBIVERT
5-digit 7-segment display
Operating/error display
Normal "LED on"
Error "LED blinks"
Double function keyboard
Figure 22: Operation with digital operator
53
OPERATION OF THE CONTROL
To Next Page
Loading...
Need help?
General