Keithley 3730 Reference Manual

Series 3700A System Switch/Multimeter Reference Manual Section 9: Introduction to TSP operation
3700AS-901-01 Rev. D/June 2018 9-29
LAN and LXI
The LAN commands have options that allow you to review and configure network settings.
The lan.config.* commands allow you to configure LAN settings over the remote interface. Note
that you must send lan.applysettings() for the configuration settings to take effect.
The lan.status.* commands help you determine the status of the LAN.
The lan.trigger[N].* commands allow you to set up and assert trigger events that are sent over
the LAN.
Other LAN commands allow you to reset the LAN, restore defaults, check LXI domain information,
and enable or disable the Nagle algorithm.
comm.lan.enable (on page 11-106)
comm.lan.rawsockets.enable (on page 11-107)
comm.lan.telnet.enable (on page 11-107)
comm.lan.vxi11.enable (on page 11-108)
comm.lan.web.enable (on page 11-109)
lan.applysettings() (on page 11-258)
lan.config.dns.address[N] (on page 11-258)
lan.config.dns.domain (on page 11-259)
lan.config.dns.dynamic (on page 11-260)
lan.config.dns.hostname (on page 11-260)
lan.config.dns.verify (on page 11-261)
lan.config.gateway (on page 11-262)
lan.config.ipaddress (on page 11-262)
lan.config.method (on page 11-263)
lan.config.subnetmask (on page 11-264)
lan.lxidomain (on page 11-264)
lan.nagle (on page 11-265)
lan.reset() (on page 11-265)
lan.restoredefaults() (on page 11-265)
lan.status.dns.address[N] (on page 11-266)
lan.status.dns.name (on page 11-267)
lan.status.duplex (on page 11-268)
lan.status.gateway (on page 11-268)
lan.status.ipaddress (on page 11-269)
lan.status.macaddress (on page 11-269)
lan.status.port.dst (on page 11-270)
lan.status.port.rawsocket (on page 11-270)
lan.status.port.telnet (on page 11-271)
lan.status.port.vxi11 (on page 11-271)
lan.status.speed (on page 11-272)
lan.status.subnetmask (on page 11-272)
lan.trigger[N].assert() (on page 11-273)
lan.trigger[N].clear() (on page 11-273)
lan.trigger[N].connect() (on page 11-274)
lan.trigger[N].connected (on page 11-275)
lan.trigger[N].disconnect() (on page 11-276)
lan.trigger[N].EVENT_ID (on page 11-276)
lan.trigger[N].ipaddress (on page 11-277)
lan.trigger[N].mode (on page 11-277)
lan.trigger[N].overrun (on page 11-278)
lan.trigger[N].protocol (on page 11-279)
lan.trigger[N].pseudostate (on page 11-280)
lan.trigger[N].stimulus (on page 11-280)
lan.trigger[N].wait() (on page 11-282)
localnode.description (on page 11-284)
localnode.password (on page 11-286)
localnode.passwordmode (on page 11-287)

Keithley 3730 Specifications

General

Brand	Keithley
Model	3730
Category	Multimeter
Language	English