Section 11: TSP command reference Series 3700A System Switch/Multimeter Reference Manual
11-284 3700AS-901-01 Rev. D/June 2018
localnode.description
This attribute stores a user-defined description and mDNS service name of the instrument.
Instrument specific (see Details)
Usage
localnode.description = "description"
description = localnode.description
User-defined description and mDNS service name of the instrument; use a string of
63 characters or less
Details
This attribute stores a string that contains a description of the instrument. This value appears on LXI
welcome page of the instrument. The value of this attribute is also used as the mDNS service name
of the instrument.
This attribute's default value contains Keithley ModelNumber #SSSSSSSS, where: ModelNumber
is the instrument's model number, and #SSSSSSSS is the instrument's eight-digit serial number. You
can change it to a value that makes sense for your system. Setting this attribute to an empty string (in
other words, setting this attribute to a string of length zero, or one consisting entirely of whitespace
characters) will revert the description to the factory default value.
When using this command from a remote node, localnode should be replaced with the node
reference, for example node[5].description.
Example
description = "System in Lab 05"
localnode.description = description
Set description to "System in Lab 05".
Also see
None
localnode.emulation
This attribute sets the instrument to report the model number as 3706 instead of 3706A.
Usage
value = localnode.emulation
localnode.emulation = value
0 or localnode.OFF: No emulation (model number is reported as 3706A)
1 or localnode.EMULATION_3706: Reports the model number as 3706