81
4
4
Features of your vehicle Wipers and washers
Type B
In the OFF position, pull the lever gently
toward you to spray washer fluid on the
windshield and to run the wipers 1-3
cycles.
Use this function when the windshield is
dirty.
The spray and wiper operation will con
-
tinue until you release the lever. If the
washer does not work, check the washer
fluid level.
If the fluid level is not sufficient, you
should add appropriate non-abrasive
windshield washer fluid to the washer
reservoir.
The reservoir filler neck is located in the
front of the engine compartment on the
passenger side.
Washer pump
To prevent possible damage to the
washer pump, do not operate the
washer when the fluid reservoir is
empty.
Obscured visibility
Do not use the washer in freezing tem
-
peratures without first warming the
windshield with the defrosters; the
washer solution could freeze on the
windshield and obscure your vision.
Wiper position
When washing the vehicle, set the wiper
switch in the off position to stop the auto
wiper operation. The wiper may operate
and be damaged if the switch is set in
the AUTO mode while washing the vehi
-
cle.
Wipers & windshields
僅 To prevent possible damage to the
wipers or windshield, do not operate
the wipers when the windshield is dry.
僅 To prevent damage to the wiper
blades, do not use gasoline, kerosene,
paint thinner, or other solvents on or
near them.
僅 To prevent damage to the wiper arms
and other components, do not
attempt to move the wipers manually.
Rear window wiper and washer
switch (for 5 Door)
Type A
To Next Page
Loading...
Need help?
General
