Maintenance
807
Emission control system
Wipe off the cream with a wet cloth
and remove water with a dry cloth.
僅 Beverages (coffee, soft drink, etc.)
- Apply a small amount of neutral
detergent and wipe until contami
-
nations do not smear.
僅Oil
- Remove oil instantly with absorb
-
able cloth and wipe with stain
remover for leather only.
僅 Chewing gum
- Harden the gum with ice and
remove gradually.
Leather
When cleaning leather products (steer
-
ing wheel, seats etc.), use neutral deter
-
gents or low alcohol content solutions. If
you use high alcohol content solutions or
acid/alkaline detergents, the color of the
leather may fade or the surface may get
stripped off.
Fabric seat cover using precau
-
tions (if equipped)
Please clean the fabric seats regularly
with a vacuum cleaner in consideration
of fabric material characteristics. If they
are heavily soiled with beverage stains,
etc., use a suitable interior cleaner. To
prevent damage to seat covers, wipe off
the seat covers down to the seams with
a large wiping motion and moderate
pressure using a soft sponge or microfi
-
ber cloth.
Velcro closures on clothing or sharp
objects may cause snagging or
scratches on the surface of the seats.
Make sure not to rub such objects
against the surface.
Emission control system
The emission control system of your
vehicle is covered by a written limited
warranty. Please see the warranty infor
-
mation contained in the Warranty &
Consumer Information manual in your
vehicle.
Your vehicle is equipped with an emis
-
sion control system to meet all applica
-
ble emission regulations.
There are three emission control sys
-
tems, as follows.
1. Crankcase emission control system
2. Evaporative emission control system
3. Exhaust emission control system
In order to assure the proper function of
the emission control systems, it is rec
-
ommended that you have your vehicle
inspected and maintained by an autho
-
rized Kia dealer in accordance with the
maintenance schedule in this manual.
Caution for the Inspection and
Maintenance Test (With Elec
-
tronic Stability Control (ESC) sys
-
tem)
僅
To prevent the vehicle from misfir
-
ing during dynamometer testing,
turn the Electronic Stability Control
(ESC) system off by pressing the
ESC switch.
僅
After dynamometer testing is com
-
pleted, turn the ESC system back on
by pressing the ESC switch again.
1. Crankcase emission control
system
The positive crankcase ventilation sys
-
tem is employed to prevent air pollution
caused by blow-by gases being emitted
from the crankcase. This system sup
-
To Next Page
Loading...
Need help?
General
