Safety Operation and Maintenance Manual
Operating and maintenance areas
2.8.2 Engine in commissioning — test-run
Fig. 34: Engine areas during commissioning/test run — view from above and coupling side
Following areas are accessible for commissioning and test run tasks:
– A – Counter coupling side (damper side)
– B – Engine sides
– C – Coupling side (flywheel side)
– D – Above the engine
It is forbidden to access to following areas:
– E - Below the engine.
2.8.3 Emergency stop
Information
The machinery owner is responsible to mark the hazardous areas and the fail-safe devices.
The emergency stops must withstand the operational conditions, kept visible and legible during the
entire life cycle.
Additional emergency stops and measures according to project standards and local regulations
and standards are possible.
The emergency buttons and signals, as the acknowledge buttons are described in the generator
set manual.
NOTICE
Property damages by misuse of emergency stops!
Misusing the emergency stops to stop the enigne could lead to property damages
u Initiate an emergency stop only in emergency situations.
Initiating an emergency stop::
u Press the emergency button.
After an emergency stop:
u Remedy to the emergency situation.
u Acknowledge the emergency buttons and signals.
46
© 2018 by Kohler Co. All rights reserved.
KD83V16 33521030601_0_1 EN_US
2018-07
To Next Page
Loading...
Need help?
General
