OPERATION OPERATION
3-92
3. Check that engine pre-heating pilot lamp (3) on the monitor
panel lights up.
4. Maintain the key in the on position until the preheating pilot
lamp (3) goes off.
5. When preheating pilot lamp (3) goes off, turn the key of ignition switch (2) to the START position (C) to crank
the engine.
The time that preheating pilot lamp (3) stays on changes according to the ambient temperature as shown in
the table below.
6. When the engine starts, release the key in starting switch
(2). The key will return automatically to the ON position (B).
REMARK
Immediately after starting the engine, run at idle. While running the engine, release the decelerator pedal and do
not operate the work equipment.
Guideline for idle time
Cold weather: At least 15 seconds
1st start after changing engine oil or engine oil filter: 20 seconds
Ambient temperature Preheat time
-5°C to -10°C (23°F to 14°F) 20 to 25 seconds
-10°C to -20°C (14°F to -4°F) 25 to 40 seconds
-20°C to -30°C (-4°F to -22°F) 40 to 45 seconds
To Next Page
Loading...
Need help?
General
