.
MAINTENANCE
SERVICE PROCEDURE
EVERY 4000 HOURS SERVICE
Maintenance for every 50, 100, 250, 500, 1000 and 2000 hours service should be carried out at the same time.
LUBRICATING
Carry out the greasing once every two years, regardless of whether the 4000 hour interval has passed.
1.
Using a grease pump, apply grease through the grease fittings marked by arrows.
2. After greasing, wipe off any old grease that was pushed out.
3.
When lubricating, stop the drive shaft so that the grease fitting of center drive shaft spline (1) will be as shown
in the figure and supply grease from under the machine.
At this time, the grease fitting is at the position indicated by the arrow at the circle below seen from the rear of
the machine.
(1) Center drive shaft spline (1 place)
View from rear of machine
(2) Front drive shaft (2 places)
View from rear of machine
4 - 63
To Next Page
Loading...
Need help?
General
