.
ATTACHMENTS, OPTIONS
HANDLING MULTI FUNCTION MONO-LEVER
ATTACHMENTS, OPTIONS
HANDLING MULTI FUNCTION MONO-LEVER
3. Push the FNR switch on the head of the multi-function lever to
the desired position.
If the directional selector pilot lamp on the machine monitor flashes, the switch or the lever is in one of the following
conditions.
When the directional selector switch actuation switch is at the OFF position, if the FNR switch is operated to F (or
R):
The pilot lamp flashes, and at the same time, the central warning lamp lights up and the alarm buzzer sounds.
Set the FNR switch to the N position.
When the engine is started, if the directional selector switch is at the ON position and the directional lever is at
N, and the FNR switch is operated to F (or R):
The pilot lamp flashes, and at the same time, the central warning lamp lights up and the alarm buzzer sounds.
Set the FNR switch to the N position.
If the directional selector switch is at the ON position and the FNR switch is operated to F (or R):
The pilot lamp flashes, and at the same time, the central warning lamp lights up and the alarm buzzer sounds.
In this condition, the machine will travel in forward or reverse according to the operation of the directional lever.
Set the directional lever and the FNR switch on the head of the multi-function lever to the N position.
6 - 26
To Next Page
Loading...
Need help?
General
