3-50
24.5.2 CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL
WARNING
When the oil filler cap is removed, oil may spurt out, so stop the
engine and wait for the oil temperature to go down, then turn
the cap slowly to release the internal pressure before removing
the cap.
1. Lower the bucket horizontally to the ground and stop the engine.
Wait for 5 minutes, then check sight gauge G.
NOTICE
When removing or installing the oil filler cap, use a tool which
matches the width of the cap groove.
It is dangerous to use a tool which does not match the groove
width, because it will slip.
2. Add oil through oil filler port F.
For details of the oil to use, see “20. USE OF FUEL, COOLANT
AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”.
24. SERVICE PROCEDURE 24. SERVICE PROCEDURE
To Next Page
Loading...
Need help?
General
