3-60
24.8 EVERY 2000 HOURS SERVICE
Maintenance for every 50, 250, 500 and 1000 hours service
should be carried out at the same time.
24.8.1 CHANGE OIL IN TRANSFER CASE
WARNING
The oil is at high temperature after the machine has been
operated. Always wait for the temperature to go down before
starting this operation.
Prepare the following.
‡ Container to catch drained oil: Min. 1.3 ¬ capacity
‡ Refill capacity: 1.3 ¬ (0.33 US gal, 0.28 UK gal)
1. Set a container under drain plug P to catch the oil, then remove
drain plug P and drain the oil. Be careful not to get the oil over
yourself.
Loosen drain plug P gradually to prevent the oil from suddenly
spurting out, then remove it slowly.
2. After draining the oil, tighten drain plug P.
Tightening torque: 59 ± 10 N•m (6 ± 1 kgf•m)
3. Add engine oil through oil filler port F to the specified level.
For details of the oil to use, see “20. USE OF FUEL, COOLANT,
AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”.
4. After adding oil, check that the oil is at the specified level. For
details, see “24.2 WHEN REQUIRED”.
5. Check that there is no leakage of oil from the transfer case.
24. SERVICE PROCEDURE 24. SERVICE PROCEDURE
To Next Page
Loading...
Need help?
General
