2-46
12.12 PARKING MACHINE
WARNING
‡ Avoid stopping suddenly. Give yourself ample room when
stopping.
‡ Do not park the machine on slopes.
If the machine has to be parked on a slope, set it facing directly
down the slope, then dig the bucket into the ground and put
blocks under the tires to prevent the machine from moving.
‡ If the control lever is touched by accident, the work equipment
or the machine may move suddenly, and this may lead to a
serious accident. Before leaving the operator’s compartment,
always set the safety lock lever securely to the LOCK position.
NOTICE
Never use the parking brake lever to brake the machine when
traveling except in an emergency. Apply the parking brake only
after the machine has stopped.
1. Release accelerator pedal 1, and depress brake pedals 2 to stop
the machine. The left and right brake pedals are interconnected,
so the machine can be stopped by pressing either of the brake
pedals.
2. Place directional lever 3 in N (neutral).
3. Depress parking brake pedal 4 to LOCK to apply the parking
brake.
Check that the parking brake pilot lamp has lighted up.
4. Lock directional lever 3 with safety lock 5.
12. OPERATION 12. OPERATION
To Next Page
Loading...
Need help?
General
