SELECT AUTO-DIGGING MODE
On “Auto Digging Mode Selection” screen, “ON” or “OFF” of the auto-digging function can be selected.
For details of the auto-digging, see “AUTO-DIGGING (3-221)”.
1.
Select “Auto Digging Mode Selection” on “Machine Setting
and Information” menu screen, then press ENTER switch
(4).
2.
“Auto Digging Mode Selection” screen is displayed.
Select a suitable digging mode for the material to handle,
then press ENTER switch (4).
“ON”
The auto-digging operates.
“OFF”
The auto-digging does not operate.
You can perform the following operations with switches (1)
to (4) on the switch panel.
(1) UP switch
Moves to the previous item (1 line above).
When on the first line, it moves to the last line.
(2) DOWN switch
Moves to the next item (1 line below).
When on the last line, it moves to the first line.
(3) RETURN switch
Cancels the selected change and returns the screen to “Machine Setting and Information” menu screen.
(4) ENTER switch
Allocates the selected change, and returns the screen to “Machine Setting and Information” menu screen.
SELECT BUCKET LEVEL POSITION
NOTICE
The bucket cylinder length when the bucket is in the level position depends on the type of the bucket.
Set the level position according to the installed bucket.
If the level position is not set appropriately, the bucket positioner may not function normally.
EXPLANATION OF COMPONENTS OPERATION
3-72
To Next Page
Loading...
Need help?
General
