1.
Raise the bucket to a suitable height, then put a block (A)
under the bucket to prevent the bucket from lowering.
Set the bottom of bucket to be level, and put a block under
the bucket at the center.
2.
Lower the bucket on the block and stabilize it.
3.
Stop the engine.
4.
Remove nuts (1), then remove segment edge (2).
5.
Clean the mounting surface of segment edge (2).
6.
Install new segment edge (2) with nuts (1), washers (3),
and bolts (4).
Tightening torque: 1600 to 2160 Nm {163 to 220 kgm}
7.
After installing the segment edge, remove the sling hook
by gas cut.
8.
After operating several hours, retighten the mounting nut.
METHOD FOR CHECKING WINDOW WASHER FLUID LEVEL, ADDING FLUID
1.
Open cover (1) on the left side of the cab.
2.
Check the fluid level in window washer tank (2).
If the level is low, add window washer fluid for automobile.
Be careful not to let dirt or dust get in when adding fluid.
3.
After checking the fluid level, close cover (1).
METHOD FOR CHECKING AND MAINTENANCE AIR CONDITIONER
METHOD FOR CHECKING LEVEL OF REFRIGERANT (GAS)
WARNING
If the refrigerant used in the air conditioner gets into your eyes or is splashed on your hands, it may
cause loss of sight or frostbite. Never touch the refrigerant. Do not loosen any part of the refrigerant
circuit.
Do not bring any open flame close to any point where the refrigerant gas is leaking.
MAINTENANCE MAINTENANCE PROCEDURE
4-35
To Next Page
Loading...
Need help?
General
