The machine input connector has 3 contacts. Each is provided with a code, so connect the cable core wires
as shown in the chart of the figure.
Terminology (Fig.3)
Contact symbol
Contact symbol
Core wire to connect Core wire to connect
Ground circuit wire Ground circuit wire
Power source circuit wire Power source circuit wire
Supply circuit Supply circuit
Connector body Connector body
Solder Solder
Insulator Insulator
Contact Contact
Core wire Core wire
Insulating tube Insulating tube
3.
Modify the other end of the cable so that it can be connected to the power supply facility.
The external power supply cable is completed.
INSTALL EXTERNAL POWER SUPPLY SYSTEM
CAUTION
• When setting up the external power supply facility, follow all related laws and regulations in that
country and use an authorized contractor.
• The electric leakage breaker is installed to prevent danger of electrocution if the electrical supply
leaks in the machine.
• Connecting the ground cable to the ground can prevent danger of electrocution.
When using the external power supply engine preheater, it is necessary to set up the following external power
supply facility.
The external power supply facility is to supply to the preheater the AC voltage electricity sent from a generator
or substation. It must have a structure that enables the external power source input cable to be connected easily
to it.
HANDLE EXTERNAL POWER SUPPLY ENGINE PREHEATER ATTACHMENTS AND OPTIONS
6-70
To Next Page
Loading...
Need help?
General
