Komatsu WA600-8 User Manual

3.
Remove mud and dust around the breather by using a
brush, etc.
Figure A shows the front axle, and B shows the rear axle.
4.
Remove the breather, immerse it in detergent liquid, and
clean it.
• Clean the breathers in 2 locations, the front and rear
sides.
• While the breather is removed, take care to prevent
entry of dusts through the mounting section of the
breather.
5.
After cleaning the breather, install it.
METHOD FOR CLEANING AIR CONDITIONER CONDENSER
kk
WARNING
• Do not use a steam cleaner for the cleaning since it is dangerous as the condenser is heated.
• If compressed air, high-pressure water, or steam hits your body directly or dirt is scattered by the
compressed air, high-pressure water, or steam, there is a danger of personal injury. Always wear
protective equipment such as protective eyeglasses and dust mask.
If dirt or dust is stuck to the condenser, clean them by using water.
If water pressure is excessive, the fin may be deformed. So cleaning by using pressurized water must be done
from a sufficiently distant position.
1.
Open the radiator guard side cover (1) on the right side of
machine, and fix it with the rod.
2.
Clean mud or dirt sticking to side cover (1) and condenser
(2) with water.
3.
After cleaning the condenser, release the lock of radiator
guard side cover (1) and close the cover.
MAINTENANCE MAINTENANCE PROCEDURE
4-27

Komatsu WA600-8 Specifications

General

Brand	Komatsu
Model	WA600-8
Category	Compact Loader
Language	English