3.
Remove the plug (1) or level plug (2), and check the oil
level.
Figure A shows the front axle, and B shows the rear axle.
If the oil is close to the lower edge of the hole of the plug,
the oil level is correct.
If the oil is not close to the lower edge of the hole of the
plug, add oil through oil filler port (F).
4.
If the oil level is correct, install the plug (1) or level plug (2).
Tightening torque: 152±24 Nm {15.5±2.5 kgm}
METHOD FOR CLEANING AXLE BREATHER
WARNING
When cleaning, apply the parking brake and fix the front and rear frames by using the frame lock bar.
Place the machine on a level ground before starting the cleaning.
1.
Stop the engine.
2.
Set the frame lock bar to LOCK position (L).
MAINTENANCE PROCEDURE MAINTENANCE
4-26
To Next Page
Loading...
Need help?
General
