• When the starting switch is turned to ON position
while the engine shutdown secondary switch is in “EN-
GINE STOP” position, “Engine Shutdown Secondary
SW in Operation” is displayed on the machine monitor.
If this screen is displayed, return the engine shutdown
secondary switch to “NORMAL” position (b).
LOAD METER CANCEL SWITCH
(if equipped)
Load meter cancel switch is located on the top of the bucket
control lever.
When the machine is operated with the load meter, measured
data can be canceled with the load meter cancel switch.
Press the load meter cancel switch, and the data which is add-
ed just before is canceled, and the screen returns to the one
before measurement.
You can cancel it for 15 seconds after the weight is displayed
or until the next weight measurement.
LOAD METER SUB TOTAL SWITCH
(if equipped)
By using the load meter sub total switch, you can set the load
meter display for the total load (addition mode) or the remain-
ing load (subtraction mode) to zero.
For details of load meter, see “HANDLE LOAD METER
(6-44)”.
STAIRCASE LIGHTING SWITCH
The staircase lighting switch is used to turn on and off the staircase lighting.
The staircase lighting switches are at 2 places, one is inside the operator's cab and the other is at the step.
Either one can be used to turn on and off the staircase lighting.
When getting on or off the machine, the staircase lighting can be turned on with the one staircase lighting
switch, and can be turned off with the other staircase lighting switch.
Staircase lighting switch inside the operator's cab
OPERATION EXPLANATION OF COMPONENTS
3-123
To Next Page
Loading...
Need help?
General
