Konica Minolta AeroDR System User Manual

3.1 Startup and shutdown
63
Chapter 3

AeroDR Battery Charger2
• Turn the power switch of the AeroDR Battery
Charger2 on, and conrm that the LED (green)
is slowly ashing.
LED (green)
Power switch

AeroDR Access Point
• When the power switch of the Power Source
Device is turned on, power is supplied to the
AeroDR Access Point, and the LED (umber) on
the AeroDR Access Point will light.
LED (umber)

Access Point
Reference
•••••••••••••••••••••••••••••••••••••
• When using a general-purpose access point, refer to its op-
eration manual.
•••••••••••••••••••••••••••••••••••••••••••••••••••••

Image processing controller
• Start the image processing controller by turning
the power switch of the image processing con-
troller on.
3.1.2 Shutdown of this device
The shutdown methods of this device are as follows.

AeroDR 1417HQ, AeroDR 1417S,
AeroDR 1717HQ, AeroDR 1012HQ,
AeroDR 2 1417HQ, AeroDR 2 1417S
• Press the power switch of the DR Detector for 5
seconds to turn it o󰀨, and conrm that the LED
(green) is turned o󰀨.
LED (green)
Power switch
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• Do not use a sharp object to operate the switch; doing so
may damage the AeroDR 2 1417HQ and AeroDR 2 1417S.
•••••••••••••••••••••••••••••••••••••••••••••••••••••

AeroDR 3 1417HD, AeroDR 3 1717HD,
AeroDR 3 1012HQ
• Press the Power SW of the DR Detector for 5
seconds to turn o󰀨 and conrm that the Infor-
mation LED (white) gradually shortens while the
triangle part flashes and the rectangular part
below it lights before the Battery LED (blue/or-
ange) goes out.
Battery LED (blue/orange)
Information LED (white) Power SW

Konica Minolta AeroDR System Specifications

General

Brand	Konica Minolta
Model	AeroDR System
Category	Medical Equipment
Language	English