Preparation for use
2
bizhub PRO C6500 / bizhub PRO C6500e 2-23
2.2 Turning on/off the power
This machine has two power switches: the main power switch and the sub
power switch.
2
Reminder
Once the main power switch is turned on, be sure not to use it in usual
operation.
To turn on the power
1 Turn on the main power switch.
– The main power switch is located
inside the machine.
Open the front door and left side
door to reach it.
When the main power switch is
turned on, the Power LED on the
control panel will light in red.
2 Turn on the sub power switch.
– The sub power switch is located
at the front of the main body.
When the sub power switch is turned
on, the Power LED will turn green.
3 The Wake-up screen and Machine Status screen with warm-up image
will be displayed.
A few seconds after the Wake-up screen appears in the touch panel,
the Machine Status screen with four types of warm-up image will be
displayed in succession for approx. 7 minutes.
?
Do you want to set reserve jobs while the machine is warming up?
% Touch the LCD screen to change the Machine Status screen with
warm-up image to the screen with the job list, then check that the
message "Ready to set reserve job" is displayed in the message
area.
To Next Page
Loading...
Need help?
General
