142
S
ETUP MENU
AUTO POWER SAVE
The camera will turn off the monitors to conserve battery power if no operation is made
within a certain period. The length of this period can be changed to 1, 3, 5, or 10 minutes.
To restore power, press the shutter-release button partway down or press the main
switch. When the camera is connected to the computer, the auto-power-save period is
set to ten minutes. This period cannot be changed.
If an operation is not made within thirty minutes, the camera will shut down. Press the
main switch to restore power.
SHUTTER FX
VOLUME
The volume of the audio signals and sound effects can be
increased or decreased in section 3 of the setup menu (p.
130). If the volume is turned off, the audio signals, focus
signal, and shutter FX are disabled.
A shutter sound effect gives positive audio
confirmation when the shutter is released. The sound
effects can be turned off in section 3 of the setup
menu (p. 130). Two shutter effects are available.
Signal 1 uses the shutter sound from the
Dynax/Maxxum 9 SLR. Signal 2 uses a mechanical
shutter sound taken from the legendary Minolta CLE.
Reset default –
Audio signals 1
Focus signal 1
Shutter FX 1
Volume 2
Power save 3 min.
To Next Page
Loading...
Need help?
General
