59
EXPOSURE AND FLASH COMPENSATION
The ambient light and flash exposure can be adjusted before the image is captured to
make the final picture lighter or darker. Exposure can be adjusted by as much as ±2Ev
in 1/3 increments (p. 111). The exposure and flash compensation will remain in effect until
it has been reset. For more on exposure and flash compensation, see page 110.
Adjustments to exposure must be set before the image is captured. When setting
exposure or flash compensation, the change in Ev is shown on the data-panel aperture
display and on the monitors. After the setting is made, the shutter-speed and aperture
displays will indicate the actual exposure.
Flash compensation
Exposure compensation
Press the exposure-compensation button (1).
Use the front control dial (2) to set exposure
compensation. The indicators are enlarged when
being adjusted.
Use the rear control dial (3) to set flash
compensation.
Press the shutter-release button partway down or
press the exposure-compensation button to
complete the operation. The values will
automatically be set if a change is not made for a
few seconds. If any other value except 0.0 was set,
an indicator will be displayed on the monitor as a
warning. Also see camera notes on page 65.
1
2
3
To Next Page
Loading...
Need help?
General
