59
EXPOSURE AND FLASH COMPENSATION
The ambient light and flash exposure can be adjusted before the image is captured to
make the final picture lighter or darker. Exposure can be adjusted by as much as ±2Ev
in 1/3 increments (p. 105). The exposure and flash compensation will remain in effect
until it has been reset. For more on exposure and flash compensation, see page 59.
Adjustments to exposure must be set before the image is captured. When setting
exposure or flash compensation, the change in Ev is shown on the monitors. After the
setting is made, the shutter-speed and aperture displays will indicate the actual
exposure.
Flash compensation
Exposure compensation
Press the up key of the controller (1) to
display the exposure and flash
compensation screen.
Use up/down keys of the controller (2) to
select exposure or flash compensation.
Use the left/right keys (3) to adjust the
degree of compensation.
Press the central button of the controller
or press shutter-release button partway
down to complete the operation. The
values will automatically be set if a
change is not made for a few seconds. If
any other value except 0.0 was set, an
indicator is displayed on the monitor as a
warning. Also see the camera notes on
page 69 and 75.
Exposure comp.
:enter:adj.:move
2
3
1
To Next Page
Loading...
Need help?
General
