The remote control mode remains active after the picture is
taken. To cancel it, select another drive mode.
78
A
DVANCED RECORDING
RECORDING WITH REMOTE CONTROL
The camera can be operated up to approximately 4m (13.1 ft.) away with the Wireless
Remote Control RC-D1 supplied with the camera. This section covers how to setup the
camera for remote control and recording operation for still and movie images. See page
126 for playback operation, and page 127 on how to replace the battery.
Remote
The remote control should be operated within
the range shown. The remote control signal
can be blocked if the zoom lens is extended,
or an accessory such as the lens hood, or a
wide-angle or telephoto converter is attached.
Backlight, and fluorescent or bright lighting
may prevent the remote control from working.
Setting up the camera for remote control
The self-timer lamp blinks to indicate the
camera has received a signal from the remote
control unit.
When the remote-control drive mode is set, the indicator appears on
the monitors.
To record still images, set the mode switch to the recording
position and select the remote control drive mode with the
drive-mode button (p. 76).
To record movies, set the mode switch on the camera to
movie recording position.
:enter:move
To Next Page
Loading...
Need help?
General
