Krone EasyCut F 320 M User Manual

16 Storage
86
EasyCut F 320 M
Original Operating Instructions 150000808_01_en
16 Storage
WARNING
Risk of injury due to non-observance of relevant safety instructions
If the relevant safety instructions are not observed, persons may be seriously injured or killed.
 To avoid accidents, the relevant safety instructions must be read and observed, refer to
page13.
WARNING
Risk of injury due to non-observance of safety instructions
If the relevant safety routines are not observed, persons may be seriously injured or killed.
 The safety routines must be read and observed to avoid accidents, refer to page24.
Placing the machine in storage at the end of the harvest season is the best possible way to
preserve the machine.
 Park the machine in a weatherproof and dry place which is far away from corrosive
substances.
 Clean the machine thoroughly.
Chaff and dirt attract moisture which causes steel parts to start rusting.
NOTICE
Damage to the machine due to water damages with high-pressure cleaner
If the water jet from a high-pressure cleaner is aimed directly at bearings and electrical/
electronic components, these parts can be damaged.
 Do not aim the water jet from high-pressure cleaner at bearings and electrics/electronic
components.
 Lubricate the machine according to lubrication chart. Do not wipe off any grease that comes
out of bearing points as the hardened grease will provide additional protection against
moisture.
 Grease the threads of setting screws and similar items.
 Relieve the relief springs.
 Disassemble the universal shaft. Lubricate the inner tubes with grease.
 Grease the grease nipples on the universal joint of the universal shaft as well as on the
bearing rings of the guard tubes, refer to page82.
INFORMATION
Follow the operating instructions of the universal shaft manufacturer.
 Lubricate the piston rods of all hydraulic cylinders liberally and insert as far as possible.
 Wet all lever joints and bearing positions which cannot be lubricated with oil.
 Touch up damaged paint and preserve all uncoated areas thoroughly with rust protection
agent.
 Check all moving components for smooth running. If necessary remove, clean, grease and
remount.
 If parts need to be replaced, use KRONE original spare parts only.

Krone EasyCut F 320 M Specifications

General

Brand	Krone
Model	EasyCut F 320 M
Category	Lawn Mower
Language	English