How to fix a KTM Motorcycle that won't crank with the electric starter?
If the engine of your KTM Motorcycle does not crank when you press the electric starter button, it could be due to an operating error. Make sure to carry out the start procedure. Another reason could be a discharged 12-V battery, so charge the battery. Also, check if fuse 1, 3, 4, or 7 is blown and change the fuses if needed. Finally, check the ground connection.
What to do if KTM Motorcycle engine turns but does not start?
If the engine of your KTM Motorcycle turns but does not start, it could be due to an operating error. Make sure to carry out the start procedure. Another reason could be an error in the electronic fuel injection, so read out the fault memory using the KTM diagnostics tool.
What to do if my KTM 390 Duke 2019 engine dies during the trip?
If the engine of your KTM Motorcycle dies during a trip, the possible causes are lack of fuel or a blown fuse (fuse 1, 3, 4, or 7). You should refuel or change the fuses of individual power consumers.
What does it mean when the ABS warning lamp lights up on my KTM 390 Duke 2019?
If the ABS warning lamp lights up on your KTM Motorcycle, the ABS fuse might be blown, so change the ABS fuses. It could also be due to a large difference in wheel speeds. In that case, stop the vehicle, switch off the ignition, and start it again. Another cause may be a malfunction in the ABS, so read out the ABS fault memory using the KTM diagnostics tool.
Why is the malfunction indicator lamp lighting up yellow on my KTM Motorcycle?
If the malfunction indicator lamp lights up yellow on your KTM Motorcycle, there may be an error in the electronic fuel injection. Read out the fault memory using the KTM diagnostics tool.
Why does my KTM 390 Duke 2019 Motorcycle engine only turn if the clutch lever is drawn?
If your KTM Motorcycle engine turns only when the clutch lever is drawn, it is possible that the vehicle is in gear. Shift the transmission to neutral position. Also, the vehicle might be in gear and the side stand is folded out, in this case shift the transmission to neutral position.
Why is the 12 V battery discharged on my KTM 390 Duke 2019 Motorcycle?
If the 12 V battery is discharged on your KTM Motorcycle, it might be because the ignition was not switched off when the vehicle was parked. In that case, charge the 12-V battery. Also, the 12-V battery might not be getting charged by the alternator, so check the charging voltage and the open-circuit current.
General| Displacement | 373.2 cc |
|---|---|
| Bore x Stroke | 89 mm x 60 mm |
| Torque | 37 Nm @ 7, 000 rpm |
| Compression Ratio | 12.6:1 |
| Transmission | 6-speed |
| Frame | Steel trellis frame, powder coated |
| Front Suspension | WP upside-down Ø 43 mm |
| Rear Suspension | WP monoshock |
| Front Tire | 110/70 R17 |
| Rear Tire | 150/60 R17 |
| Wheelbase | 1, 357 mm |
| Seat Height | 830 mm |
| Ground Clearance | 170 mm |
| Fuel Tank Capacity | 13.4 liters |
| Dry Weight | 149 kg |
| Power | 32 kW (43.5 hp) @ 9, 000 rpm |
| Fuel System | Electronic fuel injection (EFI) |
| Front Brake | 320 mm disc brake |
| Rear Brake | 230 mm disc brake |
| ABS | Bosch 9.1MB two-channel ABS |
| Engine Type | Single-cylinder, 4-stroke, liquid-cooled |
| Clutch | Wet multi-disc clutch, mechanically operated |
Essential checks and maintenance before riding.
Step-by-step guides for starting the engine and moving off.
Instructions on proper braking procedures.
Procedure for checking the engine oil level.
Steps for changing engine oil, oil filter, and cleaning oil screens.
Procedures for removing and installing the front wheel.
To Next Page