KTM 390 Duke Series 2019 User Manual

RIDING INSTRUCTIONS 9
95
Info
Do not press the electric starter button until the combi-
nation instrument function check is finished.
When starting, DO NOT open the throttle. If you open
the throttle during the starting procedure, fuel is not
injected by the engine management system and the
engine cannot start.
Press the starter for a maximum of 5 seconds. Wait for
a least 5 seconds before trying again.
This motorcycle is equipped with a safety starting sys-
tem. You can only start the engine if the transmission
is in neutral or if the clutch lever is pulled when a gear
is engaged. If the side stand is folded out and you shift
into gear and release the clutch lever, the engine stops.
9.3 Starting off
– Pull the clutch lever, engage 1st gear, release the clutch lever slowly, and simultaneously open the throttle
carefully.
Tip
If the engine dies while starting off, only pull the clutch lever and press the electric starter button. You
do not need to shift into neutral.

KTM 390 Duke Series 2019 Specifications

General

Displacement	373.2 cc
Bore x Stroke	89 mm x 60 mm
Torque	37 Nm @ 7, 000 rpm
Compression Ratio	12.6:1
Transmission	6-speed
Frame	Steel trellis frame, powder coated
Front Suspension	WP upside-down Ø 43 mm
Rear Suspension	WP monoshock
Front Tire	110/70 R17
Rear Tire	150/60 R17
Wheelbase	1, 357 mm
Seat Height	830 mm
Ground Clearance	170 mm
Fuel Tank Capacity	13.4 liters
Dry Weight	149 kg
Power	32 kW (43.5 hp) @ 9, 000 rpm
Fuel System	Electronic fuel injection (EFI)
Front Brake	320 mm disc brake
Rear Brake	230 mm disc brake
ABS	Bosch 9.1MB two-channel ABS
Engine Type	Single-cylinder, 4-stroke, liquid-cooled
Clutch	Wet multi-disc clutch, mechanically operated