MAINTENANCE WORK ON CHASSIS AND ENGINE 57
Warning
Danger of accidentsಘReduced braking due to old brake fluid.
ದ Have the front and rear brake fluid replaced according to the service plan in an authorized KTM workshop.
Warning
Environmental hazardಘProblem materials cause environmental damage.
ದ Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
Info
KTM recommends DOTb5.1 brake fluid from Motorex
®
. This has a higher wet boiling point than DOTb4 brake fluid and provides
greater safety for high demands.
Never user DOTb5 brake fluid! This is based on silicone oil and is colored purple. Oil seals and brake lines are not designed for
DOTb5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container!
400230-10
ದ Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
ದ Remove screwsb
.
ದ Remove the coverb
with membraneb.
ದ Top up brake fluid to levelb
.
Specification
Measurement ofb
5bmm (0.2bin)
Brake fluid DOT 5.1 ( P. 114)
ದ Check parts for damage and wear. Replace damaged or worn parts.
ದ Position the cover with membrane. Mount and tighten screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
Checking the front brake linings
Warning
Danger of accidentsಘReduced braking due to worn brake linings.
ದ Worn brake linings should be replaced immediately in an authorized KTM workshop.
400235-10
ದ Check the brake linings for minimum thicknessb.
» Minimum thicknessb
: ุb1bmm (ุb0.04bin)
If the minimum thickness is less than specified:
ದ Change the front brake linings. ( P. 59)
To Next Page
Loading...
Need help?
General
