Kubota 3220 User Manual

２− 5
Section 2 Installation and Power Supply
㸰㸫㸳
Power Requirements
WARNING
Prepare a power supply that meets the following conditions.
1. The power supply voltage must be the same as that indicated on the nameplate of
the centrifuge and the voltage variation must be within the range given in Table
2-1.
2. The current capacity must be more than given in Table 2-1.
3. In connecting the cord, install a knife switch or circuit breaker of given value in
Table 2-1.
When the centrifuge is connected to an outlet by means of a plug, use a 3-pin plug
with a ground terminal.
4. Use single-phase power.
5. The outlet must have a ground terminal and its ground resistance must be less
than 100 ohm.
RatedVoltage 110V 115V 220V 230V
AcceptableVoltageRange 99Vto121V 103Vto126V 198Vto242V 207Vto253V
Currentrequirement 10A 10A 6A 6A
WARNING
●
The power cable alone should be connected to the plug socket.
●
'RQRWXVHDEUDQFKHGSOXJVRFNHWZKLFKPD\FDXVHRYHUKHDWLQJRU¿UH
Table 2-1 Rated Voltage
,
Current and Acceptable Voltage Range and current requirement

Kubota 3220 Specifications

General

Brand	Kubota
Model	3220
Category	Laboratory Equipment
Language	English