Kubota 3220 User Manual

４− 5
Section 4 Service
㸲㸫㸳㸬
Inspection of Circuit Protector
Thecircuitprotectorisautomaticallyactivatedwhentheelectriccircuitfailureor
overcurrentoccurs.
Insuchacase,thewhiteportionofthecircuitprotector,locatedontherearsideofthe
centrifuge,willstickout.
Recovery procedure is as follows :
（1）Turnoffthe"POWER"switch.
（2）Aftertherotorstopscompletely,openthelidandchecktherotor,followingtheproceduregiven
in
[3-3. Opening and Closing the Lid
［
2
］
Opening the Lid During Power Failure] on Page
3-4.
（3）Closethelid,andthenpushthestickingoutwhiteportionuntilitbecomesunseen.
（4）Turnonthe"POWER"switch.
（5）Re-startoperationandseeifitworks.
Ifthecircuitprotectorisactivatedagain,contactyournearestdealer.
Circuit protector

Kubota 3220 Specifications

General

Brand	Kubota
Model	3220
Category	Laboratory Equipment
Language	English