23MAINTENANCE
ENGLISH
LUBRICANTS
To prevent serious damage to hydraulic systems, use only KUBOTA genuine fluid or its equivalent.
Note *1 Oil amount when the oil level is at the upper level of the oil level gauge.
*2 KUBOTA original transmission hydraulic fluid
IMPORTANT:
The maintenance indicated by must be done initially.
* Replace only if necessary.
** This maintenance should be done more often in dusty conditions than in normal conditions.
*** Initial elongation of the front PTO belt may occur prior to 25 hours. Adjust the tension spring length as needed to
maintain belt tension.
These items should be serviced by an authorized KUBOTA Dealer, unless the owner has the proper tools and is
mechanically proficient.
Consult your local KUBOTA Dealer for this service.
Place Capacity Lubricants
Engine crankcase 2.8 L *1
A Engine oil: API Service classification CF (or better)
Above 25 : SAE 30, SAE 10W-30 or SAE 15W-40
0 to 25 : SAE 20, SAE 10W-30 or SAE 15W-40
Below 0 : SAE 10W, SAE 10W-30 or SAE 15W-40
Transmission
(Including HST & CYLINDER)
4.5 L
A KUBOTA UDT or SUPER UDT fluid *2
Mower gear box 0.4 L A SAE #90 gear oil
King pin
Center pin
Universal joint
Spindle shaft
Belt tension pulley
Belt tension pivot
Balance shaft
Tension lever
Until grease over flows
A Multipurpose EP2 Grease
(NLGI Grade No.2)
Link fulcrum
PTO lever (fulcrum)
Front PTO cable
Brake pedal shaft
Speed control pedal shaft
Throttle cable
Mower universal joint
Front link
Mower link
Moderate Amount
A Oil or Spray type grease
Fuel tank 22 L
A No.2-D diesel fuel
A No.1-D diesel fuel if temperature is below -10
Radiator 2.1 L A Fresh clean water with anti-freeze
Radiator recovery tank 0.25 L
To Next Page
Loading...
Need help?
General
