EasyManuals Logo

Kubota G2160E User Manual

Kubota G2160E
70 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
35PERIODIC SERVICE
ENGLISH
BChanging Engine Oil
To avoid personal injury:
A Be sure to stop the engine and remove the key
before changing the oil.
A Allow engine to cool down sufficiently; oil can
be hot and may cause burns.
1. To change the used oil, remove the drain plug at the
bottom of the engine and drain the oil completely. The
used oil can be drained out more easily if the engine is
warm.
2. Fill with the new oil up to the upper notch on the
dipstick.
3. To check the oil level. Remove the dipstick, wipe it
clean, insert it and draw it out again. Check to see the
oil level is between the 2 marks.
BTransmission Oil Filter Cartridge Change
To avoid personal injury:
A Be sure to stop the engine and remove the key
before changing the oil filter cartridge.
A Allow transmission case to cool down
sufficiently; oil can be hot and may cause
burns.
1. The oil filter cartridge must be changed every 200
service hours.
2. Remove the oil filter cartridge by using the filter
wrench.
3. Lightly tighten the screw (A) by using a screwdriver.
4. Apply a slight coat of oil onto the cartridge gasket.
5. To install the new cartridge, screw it in by hand. Over
tightening may cause deformation of rubber gasket.
6. After the new cartridge has been replaced, the
transmission fluid level normally lowers a little. Add
fluid to proper level. Check for oil leaks around filter
gasket.
(1) Drain plug
(1) Oil filter cartridge

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kubota G2160E and is the answer not in the manual?

Kubota G2160E Specifications

General IconGeneral
BrandKubota
ModelG2160E
CategoryLawn Mower
LanguageEnglish

Related product manuals