Kubota WSM F3680 User Manual

3-S3
F2880, F3680, RCK72-F36, RCK72R-F36, RCK60-F36, RCK60R-F36, WSM
FRONT AXLE
3. CEHCKING, DISASSEMBLING AND SERVICING
[1] PREPARATION
Draining Transmission Fluid
1. Place oil pans underneath the transmission case.
2. Remove the drain plugs (1).
3. Drain the transmission fluid.
4. After draining, reinstall in the three drain plugs and tighten.
(When reassembling)
• Fill the transmission fluid from oil inlet (3) up to the upper line on
the dipstick (2).
• After running the engine for few minutes, stop it and check the
fluid level again, add the fluid to prescribed level if it is not correct
level.
IMPORTANT
■
• Use only KUBOTA SUPER UDT fluid. Use of other oils may
damage the transmission or hydraulic system.
• Refer to “LUBRICANTS, FUEL AND COOLANT” (See page
G-7.).
• Do not mix different brands fluid together.
W1011852
Transmission fluid Capacity
14.0 L
14.8 U.S.qts
12.3 Imp.qts
(1) Drain Plug
(2) Dipstick
(3) Oil Inlet
A : Upper Level
B : Lower Level
KiSC issued 04, 2006 A

Kubota WSM F3680 Specifications

General

Brand	Kubota
Model	WSM F3680
Category	Lawn Mower
Language	English