8-S17
F2880, F3680, RCK72-F36, RCK72R-F36, RCK60-F36, RCK60R-F36, WSM
ELECTRICAL SYSTEM
(2) Alternator
Pulley
1. Secure the hexagonal end of the pulley shaft with a double-
ended ratchet wrench as shown in the figure, loosen the pulley
nut with a socket wrench and remove it.
(When reassembling)
W1017282
Rear End Cover
1. Unscrew the three rear end cover screws and the B terminal nut,
and remove the rear end cover.
W1017367
Brush Holder
1. Unscrew the two screws holding the brush holder, and remove
the brush holder (1).
W1017462
IC Regulator
1. Unscrew the three screws holding the IC regulator, and remove
the IC regulator.
W1017539
Rectifier
1. Remove the four screws holding the rectifier and the stator lead
wires.
2. Remove the rectifier (1).
W1017612
Tightening torque Pulley nut
58.3 to 78.9 N·m
5.95 to 8.05 kgf·m
43.0 to 58.2 ft-lbs
(1) Brush Holder
(1) IC Regulator
(1) Rectifier