3JG
1-3-7
Maintenance
Description
item No.
U610 Setting system 1
Description
Makes settings for fax reception regarding the sizes of the fax paper and received images and automatic
printing of the protocol list.
Start
1. Press the enter key. The screen for selecting an item is displayed.
2. Select the item to be set using the up/down cursor keys.
Display Description
1:CUT LINE (100%) Sets the number of lines to be ignored when receiving a fax at
100% magnification.
2:CUT LINE (AUTO) Sets the number of lines to be ignored when receiving a fax
in the auto reduction mode.
3:CUT LINE (A4) Sets the number of lines to be ignored when receiving a fax
(A4R, letter) in the auto reduction mode.
Setting the number of lines to be ignored when receiving a fax at 100% magnification
Sets the maximum number of lines to be ignored if the received data volume exceeds the recording capacity
when recording the data at 100% magnification. If the number of excess lines is below the setting, those lines
are ignored. If over the setting, they are recorded on the next page.
1. Change the setting using the left/right cursor keys.
Description Setting range Initial setting Change in value per step
Number of lines to be ignored 0 to 22 3 16 lines
when receiving at 100%
Increase the setting if a blank second page is output, and decrease it if the received image does not include
the entire transmitted data.
2. Press the enter key. The value is set.
Setting the number of lines to be ignored when receiving a fax in the auto reduction mode
Sets the maximum number of lines to be ignored if the received data volume exceeds the recording capacity
when the data is recorded in the auto reduction mode. If the number of excess lines is below the setting, those
lines are ignored. If over the setting, the entire data on a page is further reduced so that it can be recorded on
the same page.
1. Change the setting using the left/right cursor keys.
Description Setting range Initial setting Change in value per step
Number of lines to be ignored 0 to 22 3 16 lines
when receiving in the auto
reduction mode
Increase the setting if a page received in the reduction mode is over-reduced and too much trailing edge
margin is left. Decrease it if the received image does not include all transmitted data.
2. Press the enter key. The value is set.
Setting the number of lines to be ignored when receiving a fax (A4R, 8 1/2 x 11) in the auto reduction
mode
Sets the maximum number of lines to be ignored if the received data volume exceeds the recording capacity
when the data is recorded in the auto reduction mode onto A4R or 8 1/2 x 11 paper under the conditions below.
If the number of excess lines is below the setting, those lines are ignored. If over the setting, the entire data on
a page is further reduced so that it can be recorded on the same page.
• With A4R present and folio absent in the drawers
• With letter-size paper present and legal-size paper absent in the drawers
1. Change the setting using the left/right cursor keys.
Description Setting range Initial setting Change in value per step
Number of lines to be ignored 0 to 22 3 16 lines
when receiving a fax
(A4R, letter) in the auto
reduction mode
To Next Page
Loading...
Need help?
General
