214
8 CO/O
2
Control
8.7.2.4 Resetting Faults
Also see Chapter 8.10.8.1 Resetting Faults.
Manual
NOTICE
For the manual reset of the fault, the fault display absolutely must be opened (call the fault
text)!
After that, acknowledge with the ENTER key.
Automatic
Automatic reset whenever the burner starts up
8.8 Electrical Connection - Connection via LSB
8.8.1 Electrical Connection
Electrical connection according to the connecting diagrams in the Appendix (see Chapter 12.3
Circuit Diagrams).
8.8.2 LAMTEC SYSTEM BUS (LSB)
Fig. 8-6 CMS MCC with CO/O
2
trim
All data and operating states relevant for the control are transferred by LSB.
For more information refer to the documents in chapter 1.1 Validity of these Instructions).
To Next Page
Loading...
Need help?
General
