Lantronix XPress DR User Manual

11: Monitor Mode
XPress™ DR Industrial Device Server User Guide 65
Command Command Name Function
AT
ARP Table Shows the unit’s ARP table entries.
TT
TCP Connection Table Shows all incoming and outgoing TCP connections.
NC
Network Connection Shows the unit’s current IP address, gateway, subnet
mask, and DNS server.
RS
Reset Resets the unit’s power.
QU
Quit Exits diagnostics mode.
G0, G1, ....,Ge,
Gf
Get configuration from
memory page
Gets a memory page of configuration information from
the device for setup record 0 to15.
S0, S1,...,Se,
Sf
Set configuration to
memory page
Sets a memory page of configuration information on the
device for setup record 0 to15.
R0, R1, ....,Rb,
Rc
Get configuration from
memory page
Gets a memory page of configuration information from
the device for setup record 16 to28.
W0, W1, ....,Wb,
Wc
Set configuration to
memory page
Sets a memory page of configuration information on the
device for setup record 16 to 28.
GM
Get MAC address Shows the unit's 6-byte MAC address.
SS
Set Security record Sets the Security record without the encryption key and
length parameters. The entire record must still be
written, but the encryption-specific bytes do not need to
be provided (they can be null since they are not
overwritten).
SA
Scan Initiates a wireless scan if the wireless interface is
enabled. Reports any stations found, including BSSID,
SSID, and RSSI. If SA is followed by a string, the string
is used to filter SSIDs before reporting. If the BSS does
not broadcast its SSID, only the BSSID and RSSI are
returned.
NS
Network Status Reports the network interfaces’ statuses. Includes
potentially negotiated parameters like speed/duplex for
Ethernet or BSSID, encryption, authentication for
wireless interfaces.
co
Set IP address, host
bits, gateway, and
DNS server IP
Example:
co 192.168.0.10 8 192.168.0.1 10001 192.168.1.10
with
192.168.0.10 = IP address of the XPress DR
8 = number of host bits
192.168.0.1 = gateway IP address
10001 = port number of the XPress DR
192.168.1.10 = IP address of the DNS Server
The XPress DR stores the setup and performs a reset.
It sends an X before the reset if the command was OK.
VN
Query full firmware
version
This command queries and displays full firmware
version in readable string format.
Responses to some of the commands are given in Intel Hex format (see The Intel Hex Format).
Note: You may be required to enter QU twice to exit monitor mode.

Lantronix XPress DR Specifications

General

Brand	Lantronix
Model	XPress DR
Category	Server
Language	English